断桥铝密封条安装之前需注意的三点事项:
Broken bridge aluminum sealing strip three matters that should pay attention to prior to installation:
1、用密封胶填缝固定玻璃时,应先用橡胶条或橡胶块将玻璃挤住,留出注胶空隙,注胶深度应不小于5mm,在胶固化前,应保持玻璃不受振动。
济南断桥铝门窗
1, when using a fixed glass sealant caulking, rubber or rubber should be used first glass choke, set aside note glue, injecting depth should not be less than 5 mm, before the adhesive curing, glass is not affected by the vibration shall be maintained.
2、橡胶密封条不能拉得过紧,下料长度比装配长度长2O-3Omm。安装时应镶嵌到位,表面平直,与玻璃、玻璃槽口紧密接触,使玻璃周边受力均匀。在转角处橡胶条应作斜面断开,并在断开处注胶粘结牢固。
2, rubber sealing strip can not pull too tight, blanking length is longer than the assembly length 2 o 3 omm. When installation should be set in place, the surface flat, notch is close contact with the glass, glass, the glass surrounding stress evenly. Cant rubber strip in the corner should be disconnected, and the disconnected note strong adhesive.
3、安装玻璃前要认真清除槽口内的杂物,如砂浆、砖屑、木块等,玻璃安放时应认真对中,保证两侧间隙均匀,并及时较正固定,防止碰撞移位,偏离槽口中心。
Three notches, installation before making glass, remove impurities, such as mortar, brick, wood, glass should be carefully placed, ensure uniform clearance on both sides, and more are fixed in time, prevent collision shift, deviating from the groove center.
本文由
济南断桥铝门窗厂友情奉献.多有关的知识请点击:
http://www.jnclmcc.com/我们将用的技术.真诚的态度.为您提供为全面的服务.多有关的知识我们将会陆续向大家奉献.敬请期待.